53292A
1.REMOVE UPPER RADIATOR SUPPORT SEAL
52119A
2.REMOVE FRONT BUMPER COVER
82112
3.REMOVE NO. 2 ENGINE ROOM WIRE
89341A
4.REMOVE NO. 1 ULTRASONIC SENSOR
Detach the 2 claws to remove the No. 1 ultrasonic sensor from the No. 2 ultrasonic sensor retainer.
Use the same procedure as for the other side.
89348D
5.REMOVE ULTRASONIC SENSOR CLIP
Using a screwdriver, detach the claw to remove the ultrasonic sensor clip from the No. 1 ultrasonic sensor as shown in the illustration.
| *1 | Protective Tape |
Tape the screwdriver tip before use.
89348A
6.REMOVE NO. 2 ULTRASONIC SENSOR RETAINER
Detach the 3 claws to remove the No. 2 ultrasonic sensor retainer from the front bumper cover.
Use the same procedure as for the other side.