81220
1.INSTALL FOG LIGHT ASSEMBLY LH
81210A
2.INSTALL FOG LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
52701
3.INSTALL FRONT BUMPER MOULDING SUB-ASSEMBLY
Attach the 4 claws and 12 guides to install the front bumper moulding sub-assembly.
Install the 15 outside moulding retainers and 4 screws.
52703
4.INSTALL FRONT BUMPER SIDE MOULDING SUB-ASSEMBLY LH
Attach the 2 claws and guide to install the front bumper side moulding sub-assembly LH.
Install the 2 screws and 3 outside moulding retainers.
52702
5.INSTALL FRONT BUMPER SIDE MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
53122B
6.INSTALL NO. 2 RADIATOR GRILLE MOULDING
Attach the 4 claws to install the No. 2 radiator grille moulding.
Install the 2 outside moulding retainers and 4 screws.
52676
7.INSTALL FRONT BUMPER LOWER SIDE SUPPORT LH
Attach the 4 claws.
Install the front bumper lower side support LH with the 2 clips.
52675
8.INSTALL FRONT BUMPER LOWER SIDE SUPPORT RH
Use the same procedure as for the LH side.
52713A
9.INSTALL FRONT BUMPER SIDE MOULDING LH
Attach the claw to install the front bumper side moulding LH.
Install the 2 outside moulding retainers.
52712
10.INSTALL FRONT BUMPER SIDE MOULDING RH
Use the same procedure as for the LH side.
52114A
11.INSTALL FRONT BUMPER EXTENSION MOUNTING BRACKET (w/ License Plate Bracket)
Install the front bumper extension mounting bracket with the 2 screws.
89348A
12.INSTALL NO. 2 ULTRASONIC SENSOR RETAINER
89348D
13.INSTALL ULTRASONIC SENSOR CLIP
89341A
14.INSTALL NO. 1 ULTRASONIC SENSOR
82112
15.INSTALL NO. 2 ENGINE ROOM WIRE
Attach the 9 clamps.
Connect each connector to install the No. 2 engine room wire.
53111
16.INSTALL RADIATOR GRILLE