89348A
1.INSTALL NO. 2 ULTRASONIC SENSOR RETAINER
Align the keyhole and protrusion as shown in the illustration.
| *a | Keyhole |
Attach the 3 claws to install the No. 2 ultrasonic sensor retainer to the front bumper cover.
Do not damage the front bumper cover with the protrusion when installing the No. 2 ultrasonic sensor retainer.
Use the same procedure as for the other side.
89348D
2.INSTALL ULTRASONIC SENSOR CLIP
Attach the claw to install the ultrasonic sensor clip to the No. 1 ultrasonic sensor.
89341A
3.INSTALL NO. 1 ULTRASONIC SENSOR
Attach the 2 claws to install the No. 1 ultrasonic sensor to the No. 2 ultrasonic sensor retainer.
Use the same procedure as for the other side.
82112
4.INSTALL NO. 2 ENGINE ROOM WIRE
52119A
5.INSTALL FRONT BUMPER COVER
53292A
6.INSTALL UPPER RADIATOR SUPPORT SEAL