82163
1.REMOVE NO. 3 FLOOR WIRE
Disconnect the 4 connectors to remove the 3 pieces of tape.
Detach the 4 clamps to remove the No. 3 floor wire.
52186A
2.REMOVE REAR BUMPER SIDE BRACKET LH
Remove the clip and 2 screws.
Detach the guide to remove the rear bumper side bracket LH.
52185A
3.REMOVE REAR BUMPER SIDE BRACKET RH
Use the same procedure as for the LH side.
52164A
4.REMOVE REAR BUMPER PLATE LH
Remove the 2 outside moulding retainers.
Detach the claw to remove the rear bumper plate LH.
52163A
5.REMOVE REAR BUMPER PLATE RH
Remove the outside moulding retainer.
Detach the claw to remove the rear bumper plate RH.
52162B
6.REMOVE NO. 1 REAR BUMPER PLATE
Remove the outside moulding retainer.
Detach the claw to remove the No. 1 rear bumper plate.
52751A
7.REMOVE REAR BUMPER CENTER MOULDING
Remove the 6 outside moulding retainers.
Detach the 4 claws to remove the rear bumper center moulding.
89341A
8.REMOVE NO. 1 ULTRASONIC SENSOR
89348D
9.REMOVE ULTRASONIC SENSOR CLIP
89348A
10.REMOVE NO. 2 ULTRASONIC SENSOR RETAINER
89348
11.REMOVE NO. 1 ULTRASONIC SENSOR RETAINER