Use these procedures to troubleshoot the LIN communication system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Using the intelligent tester, inspect the CAN communication function to make sure that there are no malfunctions in the communication system.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| DTCs are output | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Using the intelligent tester, inspect the LIN communication function to make sure that there are no malfunctions in the communication system.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| DTCs are output | B |
A
B
Refer to the Problem Symptoms Table.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Data List/Active Test
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DATA LIST / ACTIVE TEST
Terminals of ECU
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT