Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the power window control system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK FOR DTC*
    1. Check for DTCs and make a note of any codes that are output.

    2. Clear the DTCs.

    3. Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the same DTC by reproducing the symptoms indicated by the DTC.
      Result 
      Result
      Proceed to
      No DTCs are output
      A
      DTC B2311 is output
      B
      DTC B2312 is output
      B
      DTC B2313 is output
      B
      LIN communication system DTCs are output
      C
      CAN communication system DTCs are output
      D



    B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)

    C.
    GO TO LIN COMMUNICATION SYSTEM (Click here)

    D.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault not listed in problem symptoms table
      A
      Fault listed in problem symptoms table
      B



    B.
    GO TO STEP 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here).

    2. Terminals of ECU (Click here).

    3. Data List / Active Test (Click here).


    NEXT


    6.REPAIR OR REPLACE
      Result 
      Result
      Proceed to
      Door window regulator replaced or removed/installed
      A
      Door window regulator not replaced or removed/installed
      B


    B.
    GO TO STEP 8
    A


    7.RESET POWER WINDOW REGULATOR
    1. If a power window regulator switch LED is blinking, initialize the power window regulator (Click here).


    NEXT


    8.CONFIRMATION TEST

      NEXT

      END