Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

LIN COMMUNICATION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the LIN communication system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Using the Techstream, inspect the CAN communication function to make sure that there are no malfunctions in the communication system (Click here).
      Result 
      Result
      Proceed to
      No DTCs are output
      A
      DTCs are output
      B



    B.
    Go to CAN COMMUNICATION SYSTEM (Click here)
    A


    4.INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
    1. Using the Techstream, inspect the LIN communication function to make sure that there are no malfunctions in the communication system (Click here).
      Result 
      Result
      Proceed to
      No DTCs are output
      A
      DTCs are output
      B



    B.
    Go to DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    5.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Data List/Active Test (Click here)

    2. Terminals of ECU (Click here)


    NEXT


    7.ADJUST, REPAIR OR REPLACE

      NEXT

      END