Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND ACCELERATION SENSOR

YAW RATE AND ACCELERATION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL YAW RATE AND ACCELERATION SENSOR
  1. Connect the connector, and then attach the clamp to the hole of the sensor bracket.

    NOTICE:
    Securely connect the connector.

  1. Install the yaw rate and acceleration sensor with the 2 bolts.

    Torque:
    15 N*m{ 148 kgf*cm , 11 ft.*lbf }

    NOTICE:
    1. If the sensor is dropped, replace it.
    2. Make sure the bracket rotation stopper touches the installation position.
    3. Make sure that the sensor is oriented correctly.
    4. When installing the sensor, make sure to avoid impacts to the sensor.



2. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY
  1. Install the rear console box sub-assembly (Click here).



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
  1. Perform yaw rate and acceleration sensor zero point calibration (Click here).



5. CHECK YAW RATE AND ACCELERATION SENSOR SIGNAL
  1. Check the yaw rate and acceleration sensor signal (Click here).