DTC P0560 System Voltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0560 | Open in the ECM backup power source circuit (1 trip detection logic). |
|
| Related DTCs | P0560: ECM system voltage |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 3 seconds |
| MIL Operation | Immediate (MIL illuminated after next engine start) |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| ECM power source | Below 3.5 V |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY) |
Disconnect the ECM connector.
Disconnect the cable from the positive (+) battery terminal.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Battery positive terminal - F51-24 (BATT) | Always | Below 1 Ω |
| Battery positive terminal or F51-24 (BATT) - Body ground | Always | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the cable to the positive (+) battery terminal.
|
| ||||
| OK | |
| 2.INSPECT BATTERY |
Check that the battery is not depleted.
|
| ||||
| OK | |
| 3.CHECK BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
|
| ||||
| OK | |
| 4.CHECK WHETHER DTC OUTPUT RECURS |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Clear DTCs (Click here).
Turn the ignition switch off and turn the Techstream off.
Start the engine and turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Code.
Read DTCs.
| Display (DTC Output) | Proceed to |
| P0560 | A |
| No output | B |
|
| ||||
| A | ||
| ||