Home › Engine / Hybrid System › 1GR-FE FUEL › FUEL PRESSURE PULSATION DAMPER

FUEL PRESSURE PULSATION DAMPER > REMOVAL

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE
  1. Discharge the fuel system pressure (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE INTAKE AIR SURGE TANK
  1. Remove the intake air surge tank (Click here).



4. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    A223051
  1. Remove the fuel pressure regulator holder.

  1. Pull the fuel pressure pulsation damper out of the fuel delivery pipe.

  1. Remove the O-ring from the fuel pressure pulsation damper.