Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Engine Hood Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

  1. The security courtesy switch is built into the hood lock. This switch turns on when the engine hood is opened and turns off when the engine hood is closed.

WIRING DIAGRAM


B242195E01


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (SECURITY COURTESY SWITCH)
  1. Using the Techstream, read the Data List (Click here).

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Hood Courtesy SW
    Security courtesy switch /
    ON or OFF
    ON: Engine hood open
    OFF: Engine hood closed
    -

    OK:
    ON (engine hood open) and OFF (engine hood closed) appear on screen according to condition of engine hood.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT SECURITY COURTESY SWITCH


    B242188E02
  1. Disconnect the A19 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (GRD) - 2 (CTYH)
    Unlock position
    Below 1 Ω
    1 (GRD) - 2 (CTYH)
    Lock position
    10 kΩ or higher



NG
REPLACE SECURITY COURTESY SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (SECURITY COURTESY SWITCH - MAIN BODY ECU AND BODY GROUND)
  1. Disconnect the A19 switch connector.

  1. Remove the main body ECU (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A19-2 (CTYH) - A-20 (HCTY)
    Always
    Below 1 Ω
    A19-1 (GRD) - Body ground
    Always
    Below 1 Ω
    A19-2 (CTYH) or A-20 (HCTY) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)