WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Smart Key System) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs (Click here).
Recheck for DTCs (Click here). Based on the DTCs output above, try to force output of the same CAN communication system DTC, LIN communication system DTC or wireless door lock control system DTC by reproducing the symptoms indicated by the DTC.
| Result | Proceed to |
| DTC is not output | A |
| CAN communication system DTC is output | B |
| LIN communication system DTC is output | C |
| Wireless door lock control system DTC is output | D |
|
| ||||
|
| ||||
|
| ||||
| |||||
| 4.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 5.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Operation Check (Click here)
Terminals of ECU (Click here)
Data List / Active Test (Click here)
| |||||
| 6.REPAIR OR REPLACE |
| |||||
| 7.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|