Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE HOOD COURTESY SWITCH

ENGINE HOOD COURTESY SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL HOOD LOCK ASSEMBLY
  1. Apply MP grease to the sliding areas of the hood lock assembly.

  1. Connect the hood lock control cable assembly.

  1. Connect the connector.



    B237114E01
  1. Install the hood lock assembly with the 3 bolts in the order shown in the illustration.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



2. INSTALL HOOD LOCK CONTROL CABLE COVER


    B353476E01
  1. Pass the hood lock control cable assembly through the hood lock control cable cover.

  1. Attach the claw to install the hood lock control cable cover.

  1. Install the 2 screws in the order shown in the illustration.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



3. INSTALL LOW PITCHED HORN ASSEMBLY
  1. Install the low pitched horn assembly with the bolt.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Connect the connector.



4. INSTALL RADIATOR GRILLE BRACKET
  1. Install the radiator grille bracket with the 2 bolts.



5. INSTALL HIGH PITCHED HORN ASSEMBLY
  1. Install the high pitched horn assembly with the bolt.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Connect the connector.



6. INSTALL FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(Click here)


7. INSTALL FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(Click here)