Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY

HOOD LOCK CONTROL CABLE ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(Click here)


2. REMOVE FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(Click here)


3. REMOVE HIGH PITCHED HORN ASSEMBLY


B263056
  1. Disconnect the connector.

  1. Remove the bolt and high pitched horn assembly.



4. REMOVE RADIATOR GRILLE BRACKET


    B240317
  1. Remove the 2 bolts and radiator grille bracket.



5. REMOVE LOW PITCHED HORN ASSEMBLY


B263058
  1. Disconnect the connector.

  1. Remove the bolt and low pitched horn assembly.



6. REMOVE HOOD LOCK CONTROL CABLE COVER


    B353474
  1. Remove the 2 bolts.

  1. Detach the claw to remove the hood lock control cable cover.



7. REMOVE HOOD LOCK ASSEMBLY


    B237114
  1. Remove the 3 bolts.



    B237115
  1. Detach the clamp.

  1. w/ Engine Hood Courtesy Switch:
    Disconnect the connector.

  1. w/o Engine Hood Courtesy Switch:
    Disconnect the connector cap.

  1. Disconnect the hood lock control cable and remove the hood lock assembly.



8. REMOVE DOOR SCUFF PLATE ASSEMBLY LH


    B240006E01
  1. Put protective tape around the door scuff plate assembly LH.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver, detach the 4 clips, 10 claws and 2 guides to remove the door scuff plate assembly LH.

    HINT:
    Tape the screwdriver tip before use.



9. REMOVE COWL SIDE TRIM BOARD LH


    B238734
  1. Remove the clip.

  1. Detach the clip and claw to remove the cowl side trim board LH.



10. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B237118
  1. Detach the clamp.



    B237117
  1. Detach the 3 claws.

  1. Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.



11. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


  1. Using a screwdriver, disconnect the 3 clamps as shown in the illustration.


    B353475E01


    Text in Illustration 
    *1
    Hood Lock Control Cable Assembly
    *2
    Stopper
    *3
    Wire Harness
    *4
    Grommet
    *a
    Engine Room Side
    -
    -

    HINT:
    Tape the screwdriver tip before use.

  1. Pull the hood lock control cable assembly from the engine compartment to remove it.