Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the seat belt warning system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT


    3.CHECK FOR DTC*
    1. Check for DTCs and make a note of any codes that are output.

    2. Clear the DTCs.

    3. Recheck for DTCs. Based on the DTCs output above, try to cause the output of the same CAN communication system DTC, airbag system DTC or occupant classification system DTC by simulating the symptoms indicated by the DTC.
      Result 
      Result
      Proceed to
      DTC is not output
      A
      CAN communication system DTC is output
      B
      Airbag system DTC is output
      C
      Occupant classification system DTC is output
      D



    B.
    Go to CAN COMMUNICATION SYSTEM (Click here)

    C.
    Go to AIRBAG SYSTEM (Click here)

    D.
    Go to OCCUPANT CLASSIFICATION SYSTEM (Click here)
    A


    4.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).


    NEXT


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here)

    2. Data List / Active Test (Click here)

    3. Terminals of ECU (Click here)


    NEXT


    6.REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END