AIRBAG SYSTEM > SRS Warning Light Remains ON |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK BATTERY |
Measure the voltage of the battery.
|
| ||||
| OK | |
| 3.CHECK CONNECTORS |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Check that the connectors are properly connected to the center airbag sensor and combination meter.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SOURCE VOLTAGE OF CENTER AIRBAG SENSOR) |
![]() |
Disconnect the connectors from the center airbag sensor.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON.
Operate all the components of the electrical system (defogger, wipers, headlights, heater blower, etc.).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| F33-21 (IG2) - F33-25 (E1) | Ignition switch ON | 11 to 14 V |
| F33-21 (IG2) - F33-26 (E2) | Ignition switch ON | 11 to 14 V |
| *a | Rear view of wire harness connector (to Center Airbag Sensor) |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (SOURCE VOLTAGE OF COMBINATION METER) |
![]() |
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Disconnect the F14 connector from the combination meter.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| F14-17 (IG+) - F14-20 (E1) | Ignition switch ON | 11 to 14 V |
| F14-15 (B) - F14-20 (E1) | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Combination Meter) |
|
| ||||
| OK | |
| 6.CHECK SRS WARNING LIGHT (SHORT TO GROUND) |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Connect the connector to the combination meter.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON.
Check the SRS warning light condition.
|
| ||||
| OK | ||
| ||