Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Headlight Relay Circuit

for Preparation Click here


DESCRIPTION

The main body ECU receives headlight dimmer switch information signals, and illuminates the low beam headlight.

WIRING DIAGRAM


E199761E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.

1.PERFORM ACTIVE TEST USING TECHSTREAM (HEADLIGHT RELAY)
  1. Using the Techstream, perform the Active Test (Click here).

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Headlight Relay
    Low beam headlight relay
    ON/OFF
    -

    OK:
    Headlight relay operates (low beam headlights illuminate).



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT HEADLIGHT RELAY (H-LP LO)


    E108359E04
  1. Remove the headlight relay from the engine room relay block, junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied between terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied between terminals 1 and 2
    Below 1 Ω



NG
REPLACE HEADLIGHT RELAY
OK


3.CHECK HARNESS AND CONNECTOR (BATTERY - HEADLIGHT RELAY [H-LP LO])


    E199762E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Headlight relay terminal 1 - Body ground
    Always
    11 to 14 V
    Headlight relay terminal 5 - Body ground

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Headlight Relay)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (HEADLIGHT RELAY [H-LP LO] - MAIN BODY ECU)
  1. Remove the main body ECU (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Headlight relay terminal 2 - A-15 (HRLY)
    Always
    Below 1 Ω
    A-15 (HRLY) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)