Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > 4WD Control ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
4WD Control ECU Communication Stop Mode
Either condition is met:
  1. "Four Wheel Drive Control" is not displayed on the "Bus Check" screen.
  2. "4WD Control ECU Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source circuit of four wheel drive control ECU
  2. Four wheel drive control ECU branch line or connector
  3. Four wheel drive control ECU

HINT:
For vehicles with four wheel drive only.


WIRING DIAGRAM


C198939E06


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2.CHECK FOR OPEN IN CAN BUS WIRE (FOUR WHEEL DRIVE CONTROL ECU BRANCH WIRE)


    C213047E06
  1. Disconnect the F47 four wheel drive control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    F47-19 (CANH) - F47-20 (CANL)
    Ignition switch off
    54 to 69 Ω

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to Four Wheel Drive Control ECU)



NG
REPAIR OR REPLACE FOUR WHEEL DRIVE CONTROL ECU BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3.CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BATTERY AND BODY GROUND)


    C212983E05
  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Disconnect the F46 four wheel drive control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F46-4 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F46-3 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

Text in Illustration 
*a
Rear view of wire harness connector
(to Four Wheel Drive Control ECU)
Result 
Result
Proceed to
OK (for VF2A)
A
OK (for VF4BM)
B
OK (for VF2BM)
C
NG
D


B
REPLACE NO. 2 FOUR WHEEL DRIVE CONTROL ECU (Click here)

C
REPLACE NO. 2 FOUR WHEEL DRIVE CONTROL ECU (Click here)

D
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE NO. 2 FOUR WHEEL DRIVE CONTROL ECU (Click here)