Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Front Fog Light Circuit

for Preparation Click here


DESCRIPTION

The main body ECU receives headlight dimmer switch information signals, and illuminates the front fog light.

WIRING DIAGRAM


E199765E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.

1.PERFORM ACTIVE TEST USING TECHSTREAM (FRONT FOG LIGHT RELAY)
  1. Using the Techstream, perform the Active Test (Click here).

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Front Fog Light Relay
    Front fog light relay
    ON/OFF
    -

    OK:
    Front fog light relay operates (front fog lights come on).



NG
Go to step 2
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)  

2.CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)


    E202228E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    2D-9 - Body ground
    Headlight dimmer switch in tail and front fog light switch on
    11 to 14 V

    Text in Illustration 
    *a
    Component with harness connected
    (Driver Side Junction Block Assembly)



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (DRIVER SIDE JUNCTION BLOCK ASSEMBLY - FOG LIGHT ASSEMBLY)