NAVIGATION SYSTEM > Radio Broadcast cannot be Received or Poor Reception |
| 1.CHECK NAVIGATION RECEIVER ASSEMBLY |
Check the radio automatic station search function.
Check the radio automatic station search function by activating it.
| Result | Proceed to |
| Automatic station search function does not stop | A |
| Automatic station search function stops on a station | B |
|
| ||||
| A | |
| 2.CHECK OPTIONAL COMPONENTS |
Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
| Result | Proceed to |
| Optional components are not installed | A |
| Optional components are installed | B |
|
| ||||
| A | |
| 3.CHECK NAVIGATION RECEIVER ASSEMBLY |
![]() |
Preparation for check
Remove the antenna connector from the navigation receiver assembly.
Check for noise
Turn the ignition switch to ACC with the navigation receiver assembly connector connected.
Turn the radio on and tune into AM mode.
Place a screwdriver, thin wire or other metal object on the navigation receiver assembly antenna jack and check that noise can be heard from the speakers.
|
| ||||
| OK | |
| 4.CHECK WINDOW GLASS ANTENNA WIRE |
![]() |
Check for continuity in the window glass antenna wire.
| *a | Tester Probe |
| *b | Antenna Wire |
| *c | Tin Foil |
|
| ||||
| OK | |
| 5.INSPECT NAVIGATION RECEIVER ASSEMBLY (POWER SOURCE CIRCUIT) |
Disconnect the G41 navigation receiver assembly connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G41-2 (R+B1) - Body ground | Ignition switch ACC Radio switch on and AM or FM selected | 11 to 14 V |
| *a | Component without harness connected (Navigation Receiver Assembly) |
|
| ||||
| OK | |
| 6.REPLACE AMPLIFIER ANTENNA ASSEMBLY |
Replace the amplifier antenna assembly and check if radio broadcasts can be received normally (Click here).
|
| ||||
| OK | ||
| ||
| 7.REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY |
Replace the No. 2 antenna cord sub-assembly and check if radio broadcasts can be received normally (Click here).
|
| ||||
| OK | ||
| ||
| 8.REPLACE NO. 2 INSTRUMENT PANEL WIRE |
Replace the No. 2 instrument panel wire and check if radio broadcasts can be received normally (Click here).
|
| ||||
| OK | ||
| ||