Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD

RADIO ANTENNA CORD > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE ROOF HEADLINING ASSEMBLY
  1. Remove the roof headlining assembly (Click here).



3. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/o Sliding Roof)


  1. Detach the clamp and remove the antenna cord from the roof headlining.


    B240364

  1. Remove the double-sided tape from the roof headlining.



4. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/ Sliding Roof)


  1. Detach the clamp and remove the antenna cord from the roof headlining.


    B240367

  1. Remove the double-sided tape from the roof headlining.



5. REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY
  1. Disconnect the connector.



  1. Detach the 7 clamps and remove the antenna cord.


    B240370