Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Engine Coolant Temperature Receiver Gauge Malfunction

for Preparation Click here


DESCRIPTION

In this circuit, the meter CPU receives engine coolant temperature signals from the ECM using the CAN communication system. The meter CPU displays the engine coolant temperature, which is calculated based on the data received from the ECM.

WIRING DIAGRAM


E236780E01


INSPECTION PROCEDURE

HINT:
If there is an open or short in the engine coolant temperature sensor circuit, the ECM stores the DTCs. Troubleshoot the SFI system (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication DTC is output (Click here).
    Result 
    Result
    Proceed to
    CAN communication DTC is not output
    A
    CAN communication DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM (WATER TEMPERATURE METER OPERATION)
  1. Operate the Techstream according to the display and select the Active Test (Click here).

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Water Temperature Meter Operation
    Engine coolant temperature receiver gauge
    Low, Normal, High
    Confirm that the vehicle is stopped with the engine idling.

    OK:
    Engine coolant temperature receiver gauge indication is normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


3.READ VALUE USING TECHSTREAM (COOLANT TEMPERATURE)
  1. Operate the Techstream according to the display and select the Data List (Click here).

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Coolant Temperature
    Engine coolant temperature/16 to 127°C (60.8 to 260.6°F)
    After warming up: 80 to 95°C (176 to 203°F)
    1. If the value is -40°C (-40°F), the sensor is circuit open.
    2. If the value is 140°C (284°F) or more, the sensor circuit is shorted.

    OK:
    Engine coolant temperature value displayed on the Techstream is almost the same as the engine coolant temperature receiver gauge indication.

  1. Record the temperature displayed on the Techstream.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


4.READ VALUE USING TECHSTREAM (COOLANT TEMP)
  1. Operate the Techstream according to the display and select the Data List (Click here).

    Engine and ECT 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Coolant Temp
    Engine coolant temperature/Min.: -40°C (-40°F), Max.: 215°C (419°F)
    After warming up: 80 to 100°C (176 to 212°F)
    1. If the value is -40°C (-40°F), the sensor is circuit open.
    2. If the value is 140°C (284°F) or more, the sensor circuit is shorted.

    OK:
    Engine coolant temperature value displayed on the Techstream is almost the same as the previously recorded Techstream indication (Body Electrical / Combination Meter / Data List / Coolant Temperature).



NG
REPLACE ECM (Click here)
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)