Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (for Radio and Display Type)

REAR VIEW MONITOR SYSTEM (for Radio and Display Type) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use the following procedure to troubleshoot the rear view monitor system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CHECK DTC OF AUDIO AND VISUAL SYSTEM
      1. Refer to DTC Check/Clear procedures for the audio and visual system (Click here).

      2. Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B


      B.
      GO TO AUDIO AND VISUAL SYSTEM (Click here)
      A


      4.PROBLEM SYMPTOM CONFIRMATION
      1. Problem symptom confirmation.

      2. Result 
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B


      B.
      Go to step 6
      A


      5.SYMPTOM SIMULATION

        NEXT


        6.CHECK IF SAME SYMPTOM APPEARS IN AUDIO AND VISUAL SYSTEM
        1. Refer to the audio and visual system (Click here).
          Result 
          Result
          Proceed to
          Symptom does not occur
          A
          Symptom occurs
          B



        B.
        FOLLOW THE AUDIO AND VISUAL SYSTEM CHART TO PERFORM TROUBLESHOOTING (Click here)
        A


        7.PROBLEM SYMPTOMS TABLE
        1. Refer to Problem Symptoms Table (Click here).
          Result 
          Result
          Proceed to
          Fault is not listed in Problem Symptoms Table
          A
          Fault is listed in Problem Symptoms Table
          B



        B.
        Go to step 9
        A


        8.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW
        1. Terminals of ECU (Click here)


        NEXT


        9.ADJUST, REPAIR OR REPLACE

          NEXT


          10.CONFIRMATION TEST

            NEXT

            END