Home › Drivetrain ยท AXLE AND DIFFERENTIAL › FRONT DIFFERENTIAL CARRIER ASSEMBLY (for 4WD)

FRONT DIFFERENTIAL CARRIER ASSEMBLY (for 4WD) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT WHEELS


3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the No. 1 engine under cover .



4. REMOVE REAR ENGINE UNDER COVER ASSEMBLY
  1. Remove the rear engine under cover .



5. DRAIN DIFFERENTIAL OIL
  1. Stop the vehicle on a level surface.

  1. Remove the differential drain plug and gasket.

  1. Drain the oil.

  1. Install a new gasket and the differential drain plug.

    Torque:
    Front differential carrier:
    65 N*m{ 660 kgf*cm , 48 ft.*lbf }
    Rear differential carrier:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



6. REMOVE FRONT PROPELLER SHAFT ASSEMBLY
  1. Remove the front propeller shaft (Click here).



7. REMOVE FRONT DRIVE SHAFT ASSEMBLY
  1. Remove the front drive shaft (Click here).



8. REMOVE FRONT STABILIZER LINK ASSEMBLY
  1. Remove the stabilizer link .



9. REMOVE FRONT SPEED SENSOR
  1. Remove the front speed sensor (Click here).



10. DISCONNECT TIE ROD END SUB-ASSEMBLY LH
  1. Disconnect the tie rod end sub-assembly .



11. DISCONNECT TIE ROD END SUB-ASSEMBLY RH
  1. Disconnect the tie rod end sub-assembly .



12. REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
  1. Remove the front lower No. 1 suspension arm sub-assembly .



13. REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



14. REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY


C097020E06
  1. Remove the bolt and disconnect the front differential breather tube bracket.

  1. Support the front differential with a jack.

  1. Remove the front No. 1 differential mount nut.

  1. Remove the 2 front mounting bolts and nut.
    Text in Illustration 
    *1
    Mounting Bolt
    *2
    Mounting Nut

  1. for w/A.D.D. :
    Disconnect the actuator hose and connector.

  1. Lower the jack and remove the front differential.



    B084273E02
  1. Remove the 3 bolts and front No. 1 differential support.



    B084274E01
  1. Remove the 2 bolts and front No. 2 differential support.



    B084275E01
  1. Remove the 2 bolts and front No. 3 differential support.