Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1251    Open in Pump Motor Circuit

for Preparation Click here


DESCRIPTION

The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU.

DTC Code
DTC Detection Condition
Trouble Area
C1251
There is an open in the motor system circuit (motor input circuit).
  1. Pump motor wire harness connection
  2. Brake booster with accumulator pump assembly
  3. Master cylinder solenoid (Skid control ECU)

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).

HINT:
Remove the hydraulic brake booster assembly before the inspection (Click here).

1.CHECK CONNECTION OF PUMP MOTOR WIRE HARNESS
  1. Remove the hydraulic brake booster assembly (Click here).

  1. Check the tightening torque of the 2 screws which secure the wire harness connecting the master cylinder solenoid and brake booster with accumulator pump assembly .

OK:
The harness is tightened to the specified torque.

Torque:
2.9 N*m{ 30 kgf*cm , 26 in.*lbf }



NG
RETIGHTEN SCREWS
OK


2.CHECK RESISTANCE OF PUMP MOTOR WIRE HARNESS
  1. Using a screwdriver, remove the 2 screws and pull out the wire harness from the master cylinder solenoid.



    C173363E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Red wire terminal - Black wire terminal
    Always
    Below 2 Ω

    Text in Illustration 
    *1
    Pump motor wire harness
    *a
    Red wire
    *b
    Black wire



NG
REPLACE BRAKE BOOSTER WITH ACCUMULATOR PUMP ASSEMBLY (Click here)
OK


3.RECONFIRM DTC
  1. Reassemble the hydraulic brake booster assembly (Click here).

  1. Install the hydraulic brake booster assembly (Click here).

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Check if the same DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)