Home › Vehicle Exterior › LIGHTING (EXT) › FOG LIGHT ASSEMBLY

FOG LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(Click here)


2. REMOVE FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(Click here)


3. REMOVE FRONT BUMPER REINFORCEMENT STOPPER RH (w/o Intuitive Parking Assist System, for RH Side)


    B353211
  1. Detach the 2 claws and guide to remove the front bumper reinforcement stopper RH.



4. REMOVE FRONT BUMPER SIDE MOULDING SUB-ASSEMBLY LH (w/ Intuitive Parking Assist System)


    B353219
  1. Remove the 3 outside moulding retainers.

  1. Remove the 2 screws.

  1. Detach the 2 claws and guide to remove the front bumper side moulding sub-assembly LH.



5. REMOVE FOG LIGHT ASSEMBLY LH


    E280416
  1. Remove the 2 screws.

  1. Detach the 2 guides to remove the fog light assembly LH.