Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE UPPER RADIATOR SUPPORT SEAL
  1. Remove the 13 clips and upper radiator support seal.



2. REMOVE FRONT FENDER MAIN SEAL LH


    E198982
  1. Detach the 4 clips and 2 guides and remove the front fender main seal LH.



3. REMOVE FRONT FENDER MAIN SEAL RH

HINT:
Use the same procedure as for the LH side.



4. REMOVE FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(Click here)


5. REMOVE FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(Click here)


6. REMOVE HEADLIGHT ASSEMBLY LH


    E280414
  1. Remove the 3 screws and bolt.

  1. Disconnect the 4 connectors and remove the headlight assembly LH.



7. REMOVE FRONT BUMPER BAR REINFORCEMENT LH (w/o Intuitive Parking Assist System)


    B353204
  1. Remove the 3 screws and front bumper bar reinforcement LH.



8. REMOVE FRONT BUMPER BAR REINFORCEMENT LH (w/ Intuitive Parking Assist System)


    B353486
  1. Remove the 2 screws and front bumper bar reinforcement LH.