Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Horn Circuit

for Preparation Click here


DESCRIPTION

When the theft deterrent system is in the alarm sounding state, the main body ECU outputs a signal repeatedly at 0.4 second intervals, causing the horn(s) to sound.

WIRING DIAGRAM


B224123E04


INSPECTION PROCEDURE

1.CHECK HORN OPERATION
  1. Press the horn switch and check if the horn(s) sound.

    OK:
    Horn(s) operate normally.



NG
GO TO HORN SYSTEM (Click here)
OK


2.PERFORM ACTIVE TEST USING TECHSTREAM (VEHICLE HORN)
  1. Operate the Techstream according to the steps on the display and select Active Test (Click here).

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Vehicle Horn
    Vehicle horn(s)
    ON/OFF
    -

    OK:
    Horn(s) operate normally.



NG
Go to step 3
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - MAIN BODY ECU)
  1. Disconnect the 1C relay connector.

  1. Remove the main body ECU (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1C-7 - A-28 (HORN)
    Always
    Below 1 Ω
    1C-7 or A-28 (HORN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)