Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

DTC    B2797    Communication Malfunction No. 1

for Preparation Click here


DESCRIPTION

This DTC is stored when a communication error occurs between the transponder key amplifier and transponder key ECU assembly. Some possible reasons for the communication error are: 1) 2 or more ignition keys are positioned too close together, or 2) noise is occurring in the communication line.

DTC Code
DTC Detection Condition
Trouble Area
B2797
2 or more ignition keys are positioned too close to each other or noise occurs in the communication line.
  1. Key
  2. Harness or connector
  3. Transponder key amplifier
  4. Transponder key ECU assembly

WIRING DIAGRAM


B168145E09


INSPECTION PROCEDURE

NOTICE:
When the transponder key ECU assembly is replaced, refer to Registration (Click here).

1.CHECK KEY


    B213624
  1. Check whether the ignition key being used is near other ignition keys, as shown in the illustration. Also, check whether a key ring is in contact with the key grip.
    Result 
    Result
    Proceed to
    Key is near other keys and/or key ring is in contact with key grip
    A
    Key is not near other keys and key ring is not in contact with key grip
    B



B
Go to step 3
A


2.CHECK FOR DTC
  1. Separate the keys from each other or remove the key ring.

  1. Clear the DTCs (Click here).

  1. Insert a key into the ignition key cylinder, and then remove it. Repeat this for all the other keys.

  1. Check that no DTC is output (Click here).

    OK:
    DTC B2797 is not output.



NG
Go to step 3
OK

END 

3.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)
  1. Disconnect the F34 ECU connector.

  1. Disconnect the F17 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F34-15 (CODE) - F17-4 (CODE)
    Always
    Below 1 Ω
    F34-15 (CODE) or F17-4 (CODE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK TRANSPONDER KEY ECU ASSEMBLY (NOISE)


    B237349E02
  1. Using an oscilloscope, check for noise in the waveform between the terminals of the F17 amplifier connector and F34 ECU connector.
    Measurement Condition 
    Item
    Content
    Tester Connection
    F17-4 (CODE) - F34-15 (CODE)
    Tool Setting
    5 V/DIV., 20 ms./DIV.
    Condition
    Key inserted in ignition key cylinder

    OK:
    No noise is present.

    Text in Illustration 
    *a
    Component with harness connected
    (Transponder Key Amplifier)
    *b
    Component with harness connected
    (Transponder Key ECU Assembly)
    *c
    Noise should not appear



NG
FIND CAUSE OF NOISE AND REMOVE IT
OK


5.REPLACE TRANSPONDER KEY AMPLIFIER
  1. Temporarily replace the transponder key amplifier with a new or normally functioning one (Click here).


NEXT


6.CHECK WHETHER ENGINE STARTS
  1. Check that the engine starts normally.

    OK:
    Engine starts.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)
OK

END (TRANSPONDER KEY AMPLIFIER IS DEFECTIVE)