Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

DTC    B2780    Push Switch / Key Unlock Warning Switch Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is on even when the ignition switch is ON. Under normal conditions, the unlock warning switch assembly is on when the ignition switch is ON.

DTC Code
DTC Detection Condition
Trouble Area
B2780
The unlock warning switch assembly is not detected as being on when the ignition switch is ON.
  1. Transponder key ECU assembly
  2. Unlock warning switch assembly
  3. Harness or connector

WIRING DIAGRAM


B242195E10


INSPECTION PROCEDURE

NOTICE:
When the transponder key ECU assembly is replaced, refer to Registration (Click here).

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2780 is not output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.INSPECT UNLOCK WARNING SWITCH ASSEMBLY


    E198930
  1. Remove the unlock warning switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pushed
    Below 1 Ω
    Not pushed
    10 kΩ or higher



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - TRANSPONDER KEY ECU AND BODY GROUND)
  1. Disconnect the F18 switch connector.

  1. Disconnect the F34 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F34-3 (KSW) - F18-1
    Always
    Below 1 Ω
    F34-3 (KSW) or F18-1 - Body ground
    Always
    10 kΩ or higher
    F18-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)