Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

DTC    B2793    Transponder Chip Malfunction

DTC    B2794    Unmatched Encryption Code

DTC    B2795    Unmatched Key Code

for Preparation Click here


DESCRIPTION

  1. DTC B2793 is stored when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if key code registration cannot be performed normally and this DTC is output.
  2. DTC B2794 is stored when a key with an incomplete key code is inserted into the ignition key cylinder.
  3. DTC B2795 is stored when a key with a key code that is not registered in the ECU is inserted into the ignition key cylinder.

DTC Code
DTC Detection Condition
Trouble Area
B2793
A transponder chip malfunction.
Key
B2794
A key with an incomplete key code is inserted into the ignition key cylinder.
B2795
A key with an unregistered key code is inserted into the ignition key cylinder.

INSPECTION PROCEDURE

NOTICE:
When the key is replaced, refer to Registration (Click here).

1.REREGISTER KEY
  1. Clear the DTCs (Click here).

  1. Reregister the key code with the transponder key ECU assembly.

  1. Check that the engine starts with the key.

    OK:
    Engine starts.



NG
REPLACE KEY
OK

END