SLIDING ROOF SYSTEM > Sliding Roof ECU Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (SLIDING ROOF ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the S8 ECU connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S8-2 (E) - Body ground | Always | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
| S8-1 (B) - Body ground | Always | 11 to 14 V |
| S8-5 (IG) - Body ground | Ignition switch off | Below 1 V |
| S8-5 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Sliding Roof Drive Gear Sub-assembly) |
|
| ||||
| OK | ||
| ||