Home › Engine / Hybrid System › 1GR-FE STARTING › STARTER

STARTER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH
  1. Remove the exhaust manifold sub-assembly LH (Click here).



3. REMOVE STARTER COVER


    A222904
  1. Remove the 3 bolts and starter cover.



4. REMOVE STARTER ASSEMBLY


    A222905
  1. Remove the bolt and disconnect the ground wire.

  1. Disconnect the starter connector.

  1. Open the terminal cap.

  1. Remove the nut and bolt, and then disconnect the starter wire.



    A218197
  1. Remove the 2 bolts and starter.



5. REMOVE FLYWHEEL HOUSING SIDE COVER


A222907