Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

DTC    B1422/22    Compressor Lock Sensor Circuit

for Preparation Click here


SYSTEM DESCRIPTION

The ECM sends the engine speed signal to the air conditioning amplifier assembly via CAN communication.
The air conditioning amplifier assembly reads the difference between compressor speed and engine speed. When the difference becomes too large, the air conditioning amplifier assembly determines that the cooler compressor assembly is locked and turns the magnet clutch assembly off.

DTC Code
DTC Detection Condition
Trouble Area
B1422/22
Open or short in the compressor lock sensor circuit.
  1. Cooler compressor assembly (A/C lock sensor)
  2. Compressor drive belt
  3. Harness or connector
  4. Air conditioning amplifier assembly
  5. CAN communication system

WIRING DIAGRAM


E193114E08


INSPECTION PROCEDURE

HINT:
As DTC B1422/22 is also output when the compressor drive belt is damaged or loose, inspect the belt before performing troubleshooting.

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
  1. Use the Techstream to check if the CAN communication system is functioning normally.
    Result 
    Result
    Proceed to
    CAN DTC is not output
    A
    CAN DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.INSPECT COOLER COMPRESSOR ASSEMBLY (A/C LOCK SENSOR)


    E193115
  1. Remove the cooler compressor assembly (A/C lock sensor) (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    160 to 320 Ω



NG
REPLACE COOLER COMPRESSOR ASSEMBLY (A/C LOCK SENSOR) (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - A/C LOCK SENSOR)
  1. Disconnect the F42 amplifier connector.

  1. Disconnect the B41 sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F42-8 (LOCK) - B41-1
    Always
    Below 1 Ω
    F42-13 (SG-2) - B41-2
    Always
    Below 1 Ω
    F42-8 (LOCK) - Body ground
    Always
    10 kΩ or higher
    F42-13 (SG-2) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK (When troubleshooting according to problem symptoms table)
    A
    OK (When troubleshooting according to the DTC)
    B
    NG
    C



B
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)