Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR
  1. Apply a light coat of engine oil to the O-ring of the sensor.

    NOTICE:
    1. When reusing the sensor, inspect the O-ring.
    2. If the O-ring has scratches or cuts, replace the sensor.

  1. Install the sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the sensor connector.



2. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    A224743
  1. Hook the No. 1 engine under cover sub-assembly to the vehicle body as shown in the illustration.

  1. Install the 4 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



3. INSTALL COOLER COMPRESSOR ASSEMBLY
  1. Install the cooler compressor (Click here).



4. INSTALL GENERATOR ASSEMBLY
  1. Install the generator (Click here).