Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE GENERATOR ASSEMBLY
  1. Remove the generator (Click here).



2. REMOVE COOLER COMPRESSOR ASSEMBLY
  1. Remove the cooler compressor (Click here).



3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts.



    A224743
  1. Unhook the No. 1 engine under cover sub-assembly from the vehicle body as shown in the illustration.



4. REMOVE CRANKSHAFT POSITION SENSOR


    A076417
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.