REAR CRANKSHAFT OIL SEAL > REMOVAL |
| 1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY |
for 2WD:
Remove the automatic transmission (Click here).
for 4WD:
Remove the automatic transmission (Click here).
| 2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
![]() |
Using SST, hold the crankshaft.
![]() |
Remove the 8 bolts, rear spacer, drive plate and ring gear sub-assembly and front spacer.
| 3. REMOVE REAR CRANKSHAFT OIL SEAL |
![]() |
Using a knife, cut off the lip of the oil seal.
| *1 | Cut Position |
Using a screwdriver, pry out the oil seal.