INTUITIVE PARKING ASSIST SYSTEM > Front Clearance Sonar Sensor LH Circuit |

| 1.INSPECT NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH) |
Remove the No. 1 ultrasonic sensor (front corner sensor LH) (Click here).
Inspect the No. 1 ultrasonic sensor (front corner sensor LH) (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (FRONT CORNER SENSOR LH - CLEARANCE WARNING ECU ASSEMBLY) |
Disconnect the E2 No. 1 ultrasonic sensor (front corner sensor LH) connector.
Disconnect the F95 clearance warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E2-1 (E) - F95-12 (E6) | Always | Below 1 Ω |
| E2-2 (S) - F95-13 (S6) | Always | Below 1 Ω |
| E2-1 (E) - Body ground | Always | 10 kΩ or higher |
| E2-2 (S) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||