Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the air conditioning system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK

      NEXT


      3.INSPECT BATTERY VOLTAGE
      1. Measure the voltage of the battery.

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


      NEXT


      4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
      1. Use the Techstream to check if the CAN communication system is functioning normally.
        Result 
        Result
        Proceed to
        CAN DTC is not output
        A
        CAN DTC is output
        B



      B.
      Go to CAN COMMUNICATION SYSTEM (Click here)
      A


      5.CHECK PANEL DIAGNOSIS
      1. Check panel diagnosis (Click here).

        1. Indicator Check

        2. Sensor Check


      NEXT


      6.CHECK FOR DTC*
      1. Check for DTCs and note any codes that are output (Click here).

      2. Clear the DTCs (Click here).

      3. Based on the DTCs output above, try to force output of the air conditioning system DTC by simulating the conditions indicated by the DTC. Then recheck for DTCs.
        Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B



      B.
      Go to DIAGNOSTIC TROUBLE CODE CHART (Click here)
      A


      7.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).
        Result 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B



      B.
      Go to step 9
      A


      8.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Terminals of ECU (Click here)

      2. Data List / Active Test (Click here)

      3. On-vehicle Inspection

      4. Inspection


      NEXT


      9.ADJUST, REPAIR OR REPLACE

        NEXT


        10.CONFIRMATION TEST

          NEXT

          END