Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Smart Key System)

DTC    B2799    Engine Immobiliser System Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when one of the following occurs: 1) the ECM detects errors in its own communications with the ID code box; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the ID code box and ECM is different and an engine start is attempted.
Before troubleshooting for this DTC, make sure no certification ECU DTCs are output. If output, troubleshoot the certification ECU DTCs first.

DTC Code
DTC Detection Condition
Trouble Area
B2799
One of the following conditions is met:
  1. An error in the communication between the ECM and ID code box.
  2. An error in the communication lines.
  3. The communication ID is different during communication with the ID code box.
  1. Harness or connector
  2. ECM
  3. ID code box

WIRING DIAGRAM


B235863E03


INSPECTION PROCEDURE

NOTICE:
When the ID code box is replaced, refer to Registration (Click here).

1.CHECK CONNECTION OF CONNECTOR
  1. Turn the engine switch off.

  1. Check that the connectors are properly connected to the ECM and ID code box.

    OK:
    Connectors are properly connected.



NG
CONNECT CONNECTORS PROPERLY
OK


2.CHECK HARNESS AND CONNECTOR (ID CODE BOX - ECM)
  1. Disconnect the F72 box connector.

  1. Disconnect the F50 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F72-5 (EFII) - F50-20 (IMO)
    Always
    Below 1 Ω
    F72-6 (EFIO) - F50-14 (IMI)
    F72-5 (EFII) or F50-20 (IMO) - Body ground
    Always
    10 kΩ or higher
    F72-6 (EFIO) or F50-14 (IMI) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REGISTER RECOGNITION CODES
  1. Register the recognition codes in the ECUs (Click here).


NEXT


4.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID (Click here).


NEXT


5.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


6.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2799 is not output.



NG
Go to step 7
OK

END (ECU COMMUNICATION ID IS NOT REGISTERED CORRECTLY) 

7.REPLACE ECM
  1. Temporarily replace the ECM with a new or normally functioning one (Click here).


NEXT


8.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


9.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2799 is not output.



NG
REPLACE ID CODE BOX (Click here)
OK

END (ECM IS DEFECTIVE)