DTC U0208 Lost Communication with "Seat Control Module A" |
| DTC Code | DTC Detection Condition | Trouble Area |
| U0208 | There is no communication from the front power seat switch LH. |
|

| 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and branch wire.
| NEXT | |
| 2.CHECK FOR OPEN IN CAN BUS WIRE (FRONT POWER SEAT SWITCH LH BRANCH WIRE) |
![]() |
Disconnect the b19 front power seat switch LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| b19-8 (CANP) - b19-7 (CANN) | Ignition switch off | 54 to 69 Ω |
| *a | Rear view of wire harness connector (to Front Power Seat Switch LH) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT SWITCH LH - BATTERY AND BODY GROUND) |
![]() |
Connect the cable to the negative (-) battery terminal.
Disconnect the b18 front power seat switch LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| b18-2 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| b18-7 (+B1) - Body ground | Always | 11 to 14 V |
| b19-12 (SYSB) - Body ground | Always | 11 to 14 V |
| *a | Rear view of wire harness connector (to Front Power Seat Switch LH) |
|
| ||||
| OK | ||
| ||