DTC B1273 Sliding Roof ECU Communication Stop |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1273 | No communication between the sliding roof drive gear sub-assembly and main body ECU (multiplex network body ECU) for 10 seconds or more. |
|

| 1.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SLIDING ROOF DRIVE GEAR) |
Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly (Click here).
Disconnect the S8 sliding roof drive gear sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A-16 (LIN2) - S8-4 (MPX1) | Always | Below 1 Ω |
| A-16 (LIN2) or S8-4 (MPX1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SLIDING ROOF DRIVE GEAR - BATTERY AND BODY GROUND) |
![]() |
Disconnect the S8 sliding roof drive gear sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S8-2 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S8-1 (B) - Body ground | Always | 11 to 14 V |
| S8-5 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Sliding Roof Drive Gear Sub-assembly) |
|
| ||||
| OK | |
| 5.REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY |
Temporarily replace the sliding roof drive gear sub-assembly with a new or normally functioning one (Click here).
| NEXT | |
| 6.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 7.CHECK FOR DTC |
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||