DTC B2323 Rear Door RH ECU Communication Stop |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2323 | No communication between the rear power window regulator motor assembly RH and main body ECU (multiplex network body ECU) for 10 seconds or more. |
|

| 1.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - REAR POWER WINDOW REGULATOR MOTOR RH) |
Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly (Click here).
Disconnect the J2 rear power window regulator motor assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A-16 (LIN2) - J2-9 (LIN) | Always | Below 1 Ω |
| A-16 (LIN2) or J2-9 (LIN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR MOTOR RH - BATTERY AND BODY GROUND) |
![]() |
Disconnect the J2 rear power window regulator motor assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J2-1 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J2-2 (B) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Rear Power Window Regulator Motor Assembly RH) |
|
| ||||
| OK | |
| 5.REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH |
Temporarily replace the rear power window regulator motor assembly RH with a new or normally functioning one (Click here).
| NEXT | |
| 6.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 7.CHECK FOR DTC |
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||