Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Mute Signal Circuit between Stereo Component Amplifier and Telematics Transceiver

for Preparation Click here


DESCRIPTION

The DCM (telematics transceiver) sends a mute signal to the stereo component amplifier assembly.
The stereo component amplifier assembly controls the volume according to the mute signal from the DCM (telematics transceiver).

WIRING DIAGRAM


E283660E03


INSPECTION PROCEDURE

1.INSPECT DCM (TELEMATICS TRANSCEIVER)


    E283020E04
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F39-17 (MUTE) - Body ground
    Ignition switch ACC, audio system is playing
    → Emergency call mode
    Above 3.5 V
    → Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (DCM (Telematics Transceiver))



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - DCM (TELEMATICS TRANSCEIVER))
  1. Disconnect the N11 stereo component amplifier assembly connector.

  1. Disconnect the F39 DCM (telematics transceiver) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    N11-24 (TMUT) - F39-17 (MUTE)
    Always
    Below 1 Ω
    N11-24 (TMUT) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY
  1. Reconnect the N11 stereo component amplifier assembly connector.

  1. Disconnect the F39 DCM (telematics transceiver) connector.



    E176650E35
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F39-17 (MUTE) - Body ground
    Ignition switch ACC
    Above 3.5 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to DCM (Telematics Transceiver))



NG
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)
OK

REPLACE DCM (TELEMATICS TRANSCEIVER) (Click here)