Home › Vehicle Interior › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > Key Reminder Buzzer does not Sound

for Preparation Click here


DESCRIPTION

The key reminder warning buzzer sounds when the driver side door is opened while the ignition switch is ACC or off and the key is in the ignition key cylinder. The key reminder warning buzzer is activated when the main body ECU (multiplex network body ECU) sends an unlock warning switch signal and front door courtesy light switch LH signal to the combination meter.

WIRING DIAGRAM


E200517E01


INSPECTION PROCEDURE

HINT:
Since the key reminder warning system has functions that use CAN communication, first confirm that there is no malfunction in the communication system by inspecting CAN communication in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.

1.READ VALUE USING TECHSTREAM (FRONT DOOR COURTESY LIGHT SWITCH)
  1. Check the Data List for proper functioning of the front door courtesy light switch (Click here).

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    FL Door Courtesy
    Front door courtesy light switch LH signal / ON or OFF
    ON: Front door LH closed
    OFF: Front door LH open
    -

    OK:
    On tester screen, each item changes between ON and OFF according to above chart.



NG
GO TO LIGHTING SYSTEM (INT) (Click here)
OK


2.READ VALUE USING TECHSTREAM (UNLOCK WARNING SWITCH)
  1. Check the Data List for proper functioning of the unlock warning switch (Click here).

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Unlock Warning SW
    Unlock warning switch signal / ON or OFF
    ON: Key in ignition key cylinder
    OFF: No key in ignition key cylinder
    -

    OK:
    On tester screen, each item changes between ON and OFF according to above chart.



NG
Go to step 3
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)  

3.INSPECT UNLOCK WARNING SWITCH ASSEMBLY
E198930E03
  1. Remove the unlock warning switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (UN+) - 2 (UN-)
    Not pushed
    10 kΩ or higher
    Pushed
    Below 1 Ω



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH ASSEMBLY - MAIN BODY ECU AND BODY GROUND)
  1. Disconnect the F18 unlock warning switch connector.

  1. Disconnect the F9 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F18-1 (UN+) - F9-17 (KSW)
    Always
    Below 1 Ω
    F18-2 (UN-) - Body ground
    Always
    Below 1 Ω
    F9-17 (KSW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK COMBINATION METER ASSEMBLY (OPERATION)
  1. Temporarily replace the combination meter assembly with a new or normally functioning one (Click here).

  1. Check the key reminder warning system (Click here).

    OK:
    The key reminder warning system functions properly.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
OK

END (COMBINATION METER ASSEMBLY IS DEFECTIVE)