DTC P060A Internal Control Module Monitoring Processor Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060A | There is an ECM sub CPU error. | ECM |
| Related DTCs | None |
| Required sensors/Components (Main) | ECM |
| Required sensors/Components (Related) | - |
| Frequency of operation | Continuous |
| Duration | - |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not stored | None |
| Either condition is met: | Condition 1 or 2 |
| 1. All conditions are met: | - |
| - CPU reset | 1 time or more |
| - Learned throttle position - Learned accelerator pedal position | 0.4 V or higher |
| - Electronic throttle actuator | OFF |
| 2. CPU reset | 2 times or more |

| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK FOR DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch to ON.
Check for DTCs.
|
| ||||
| OK | ||
| ||