DTC P060D Internal Control Module Accelerator Pedal Position Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060D | There is an ECM main CPU error. | ECM |
| Related DTCs | P060D: Internal control module, Accelerator pedal position |
| Required sensors/Components (Main) | ECM |
| Required sensors/Components (Related) | - |
| Frequency of operation | Continuous |
| Duration | 1 second |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not present | None |
| Difference of main accelerator pedal position and sub accelerator pedal position | 0.3 V or higher |

| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK FOR DTC |
Clear DTCs (Click here).
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch to ON.
Check for DTCs.
|
| ||||
| OK | ||
| ||