Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > Washer Fluid Level Warning Switch Circuit

for Preparation Click here


DESCRIPTION

When the volume of washer fluid decreases to below a certain level (when the level warning switch is turned on), the multi-information display in the combination meter assembly displays "LOW WASHER FLUID" to warn the driver.

WIRING DIAGRAM


E280740E01


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (WASHER SWITCH)
  1. Use the Data List to check if the level warning switch assembly is functioning properly (Click here).


Combination Meter 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Washer Switch
Level warning switch / ON or OFF
ON: Washer jar and tank empty
OFF: Washer jar and tank full
-

OK:
On the Techstream screen, each item changes between ON and OFF according to the above chart.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT LEVEL WARNING SWITCH ASSEMBLY
  1. Inspect the level warning switch assembly (Click here).



NG
REPLACE WASHER FLUID LEVEL WARNING SWITCH ASSEMBLY (Click here)
OK


3.CHECK WASHER WIRING ASSEMBLY
  1. Disconnect the A27 and LW washer wiring assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A27-3 (S) - LW-1
    Always
    Below 1 Ω
    A27-6 (E) - LW-2
    Always
    Below 1 Ω
    A27-3 (S) or LW-1 - Body ground
    Always
    10 kΩ or higher
    A27-6 (E) or LW-2 - Body ground
    Always
    10 kΩ or higher



NG
REPLACE WASHER WIRING ASSEMBLY
OK


4.CHECK HARNESS AND CONNECTOR (LEVEL WARNING SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND)
  1. Disconnect the A27 washer wiring assembly connector.

  1. Disconnect the F14 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A27-3 (S) - F14-27 (WLVL)
    Always
    Below 1 Ω
    A27-6 (E) - Body ground
    Always
    Below 1 Ω
    A27-3 (S) or F14-27 (WLVL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)