Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH

WASHER LEVEL WARNING SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(Click here)


3. REMOVE FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(Click here)


4. REMOVE FRONT FENDER LINER RH
(Click here)


5. DRAIN WINDSHIELD WASHER FLUID


    E198963
  1. Disconnect the washer hose from the hose of the windshield washer motor and pump assembly and drain the windshield washer fluid.



6. REMOVE WASHER INLET SUB-ASSEMBLY


    E198964
  1. Detach the clip and remove the washer inlet sub-assembly.



7. REMOVE WASHER JAR


    E198971
  1. Disconnect the connector.



    E198972
  1. Remove the 3 screws.



    E198973
  1. Detach the guide to remove the washer jar.



8. REMOVE WASHER JAR PROTECTOR


    E199251
  1. Detach the 3 claws to remove the washer jar protector.



9. REMOVE LEVEL WARNING SWITCH ASSEMBLY


    E198966E01
  1. Disconnect the connector.

  1. Remove the level warning switch assembly from the packing of the washer jar.
    Text in Illustration 
    *1
    Packing