DTC C1436 Yaw Rate Sensor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1436 | Either condition is met:
| Yaw rate and acceleration sensor |
| 1.CHECK DTC (CAN COMMUNICATION SYSTEM) |
Check for DTCs (Click here).
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| A | |
| 2.READ VALUE USING TECHSTREAM (YAW RATE SENSOR) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select the Data List mode on the Techstream (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Yaw Rate Sensor | Yaw rate and acceleration sensor 1 reading/ Min.: -128°/s, Max.: 127°/s | Vehicle stationary: 0°/s Right turn: -128 to 0°/s Left turn: 0 to 127°/s | - |
Check that the yaw rate and acceleration sensor output value is displayed on the Techstream.
| Result | Proceed to | |
| NG | Yaw rate and acceleration sensor output value is 0°/s when vehicle is stationary, but value fluctuates when turning | A |
| Yaw rate and acceleration sensor output value is not 0°/s when vehicle is stationary | B | |
| OK | C | |
|
| ||||
|
| ||||
| A | |
| 3.CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate and acceleration sensor is installed properly (Click here).
|
| ||||
| OK | ||
| ||